Woodworking Attach Table Top

Attach Flange to Table Top.

Woodworking attach table top. Mark all of your mounting holes with the legs in place. Measure or eyeball where you want each leg. Use washers and just snug the screws so the tabletop can move under the screw heads.

Regardless of the method you choose it should meet the following criteria. The top must be firmly attached to the base. The most important requirements of any method are 1 to keep the top firmly in contact with the undercarriage preventing it from warping more than minimally and 2 to allow the top to move across its grain as the wood expands and contracts with changes in humidity.

Place table top on the base and screw it down from underneath with 12 6 flat head screws through the other end of the figure 8 fastener. A solid-wood top must be allowed to move seasonally. Put two pieces of wood on either side of the leg forming part of the apron around it and then attach the metal legs to the apron using custom dowels similar to how its done in this video httpsyoutubeF-SxsnG7CLc just without glueing it to the top.

Chisel out the sides of the hole to allow the table top fastener to move freely. Screw figure 8 fastener to base with 12 6 flat head screws. Dont over tighten just snug.

In this video I show you how I attach table tops to bases. Theres more than one way to attach a solid wood table top. To attach metal legs youll need the legs Flange fittings screws a drill or wrench and the feet covers casters or plugs.

Be sure that the legs are an equal distance from the corners. Remove legs and drill holes for threaded inserts. Use your pocket hole screws to attach the middle of the top to your legs.