How To Work With Warped Wood

Place the wood in a clamp carefully over-tightening the clamp until the warped area starts to straighten out.

How to work with warped wood. How to Straighten Warped Wood Basic Hacks Tips Read More. Keep the wood clamped and wrapped in a warm location. I am making four rustic looking table tops with planks of hemlock and butternut.

Keep going until the entire piece is no longer warped. While some wood is kiln dried to accelerate drying other wood is air-dried. Check the progress of your work regularly and remove the wood from the clamp if there are signs of damage.

Soak your chosen towels in water remove the excess and follow these steps. If you are into wood furniture you may have to experience when using this several times. But the purpose of all drying is to bring wood to an Equilibrium Moisture Content EMC that will help prevent it from taking on or losing excessive moisture once milled.

Place the wet towel over the wooden tabletop wood cabinet door or other item and wait for the iron to reach its maximum heat. The most common reason for wood to warp is it has not been properly dried. Begin to iron the towel as you usually would.

Leave the clamp on for one week. In this case you should wrap the warped wood with moist towels. Place the wood onto your ironing board with the towel on top of it.

Work the iron slowly over the warped area allowing the heat from the iron to pull moisture from the wood. Generally fixing your warped wood for your wood signs is not difficult. Press the iron over the warped surface.