How To Prepare Chipped Woodwork For Painting

Clean out any loose material and scrape off.

How to prepare chipped woodwork for painting. Previously painted wood etc. Hold the edge of the craft stick perpendicular to the trim and run it across the surface of the. Also make sure to overfill the area a little so that when youre ready to sand you can sand it.

If your wooden surfaces are new and unpainted then start by making sure they are clean before inspecting them for any knots in the grain. Using a putty knife scoop out some Ready Patch and smooth it over the surface of the crater left by the chipped paint. And when youre done doing that check out my guide for taking proper care of and cleaning paintbrushes so they last a long time.

This will ensure all dust and any particles left behind from moving the furniture away from the walls will be collected. Paint thinner will leave some residue on the surface that will hinder paint adhesion. It all depends on how bad the existing paintwork is if the paintwork is sound and is just chipped in places then you can just sand down the woodwork and use a wood filler on the chips sand down the filler once dry and then prime the places where filler has been used then do 2 coats of satinwood again if the general paintwork is sound then concentrate more on sanding rather than.

Apply the primer in a. Apply wood filler to deeper chips using a craft stick to trowel in a tiny bit of filler at a time. Step 2 Knotting solution will stop the resin in the wood from leaking into the paintwork.

As a whole rubbing alcohol as well as a vinegar and water mixture can be used to clean metal before painting it. Work it in several directions to fill any nooks and crannies. Before you paint your woodwork you need to prepare it.

Paint thinner on the other hand should not be used to clean metal to prepare it for painting. Tools needed to prepare interior woodwork for painting. Use the side of the tray to wipe excess paint off the brush helping to avoid drips while painting.