How To Do Metal Framing Studs

In order to make the cuts we recommend you to use straight-cut thin snips.

How to do metal framing studs. Cuts both sides with snips and score a line on the back. Make sure you leave it loose until the drywall goes up. Lay out the position of the track strike chalk lines and drill a hole through the metal and into the concrete the full length of the screw.

Wire the skin nail plate over the perceived. This allows for the installation of wallboard and other wall sheet products that. If you can hang drywall on wooden studs you can do the same on metal ones but put away your drywall hammer.

The proper way to handle an inside corner when you use metal stud framing is sliding that first sheet into the inside corner and fastening the last stud adjacent to the drywall. Use the one that works best for you. Framing with metal studs After you have installed the metal track you have to install the first layer of studs.

Step 3 Secure the backerboard sheet into place with sheet metal screws through the panel into the metal framing using a power screwdriver. The metal snips are available in three different directional cuts. How to Hang Drywall on Metal Studs.

A time lapse of the verycoolguys hanging drywall and installing metal stud framingA quick video showing how we built new offices using metal studs and dr. Just like wood framing metal studs should be spaced 16 or 24 inches apart. Use a hammer drill fitted with a carbide tipped masonry bit.

How to bend metal studs The best way to bend metal studs is to cut their flanges every 2-3 on both sides. Use a metal cutter to cut spaces in the cabinet board. The metal snips and the chop box.